article thumbnail

How to open the router setup page using Ethernet to typec adapter on router which has off the lan port? [closed]

Network Engineering

have a Ethernet to typec device that let me connect to the router without password.It is fine if the lan port is opened but when the lan port is off it doesn't open router setup page? I have a mobile phone (Realme c55) which support otg.I

LAN 52
article thumbnail

CCNA: TCP SEQ and Port Number

The Network DNA

CCNA: TCP Sequence & Port Number This article can be read as the second part of the previous article CCNA: 3-Way Handshake where we discussed what makes TCP a reliable protocol for transmitting information. Lets discuss the TCP SEQ and Port numbers in this article. These applications are identified using the port numbers.

Port 52
Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Trending Sources

article thumbnail

Lab] Cisco, ensuring traffic goes between a specific switch port and trunk port

Network Engineering

how does one protect vlanX from receiving any traffic on a vlan that is setup specifically to tie physical port gi2/12 to a specific vm through a trunk/lag port ? due to circumstance I am currently unable to install another network card to allow a dedicated Ethernet port. GI2/12 is connected directly to the isp modem.

Port 52
article thumbnail

CCNA: Address Resolution Protocol (ARP)

The Network DNA

To do that it builds the Ethernet Frame and puts its MAC address as the Source MAC address (SMAC) and layer 2 broadcast address (ff:ff:ff:ff:ff:ff). A switch forwards the broadcast out all the ports in same VLAN (except the port where broadcast was received). PC-2 now creates an Ethernet frame to respond to the ARP.

article thumbnail

Multi-Path TCP: revolutionizing connectivity, one path at a time

CloudFaire

After the initial TCP handshake, each peer may announce additional addresses (and ports) on which it can be reached. First, in the handshake TCP packet each peer specifies the " Do not attempt to establish new subflows to this address and port " bit, also known as bit [C], in the MPTCP TCP extensions header. There are caveats though.

TCP 137
article thumbnail

TRex traffic generator and VPP as a DUT

Network Engineering

Ethernet Controller X710 for 10GbE SFP+ 1572' drv=vfio-pci unused=i40e 0000:1b:00.0 Ethernet Controller X710 for 10GbE SFP+ 1572' drv=vfio-pci unused=i40e 0000:1b:00.0 I connected two 10GbE X710 cables between TRex and VPP machine which are both Linux and safely assigned those interfaces to dpdk-compatible drivers. is it possible?

article thumbnail

CCNA: MAC Address Table

The Network DNA

This table is populated automatically when a switch receives a frame on a port. As a frame is received on a port, its source MAC address is noted. The switch receives the frame from PC-1 that contains the MAC address 80::01 on port 1. Port 1 is configured as a member of VLAN-11. Then PC-1 wants to communicate with PC-2.